14
NEW GOLIA PLUS User Manual_
May 2013 Edition
Tilt enable microswitch
There is a tilt enable microswitch on the end of the handle
which enables the machine to be started only when the handle
is tilted for the start-up phase (in accordance with instructions
on pg. 13).
When the handle is tilted the button is released and this
activates the power.
If however the contact button is blocked with dust or deposits
the machine will not start even if the handle is tilted and the
instructions on page 3 are carried out.
Stopping the machine
1. Release the red switch levers.
2. Lift the black release lever with
both hands.
3. Put the handle in a vertical
position.
4. Lower the black release lever to
lock the handle.
IMPORTANT
If it is difficult to start the machine in low temperatures in winter remove the accessory disc and start the motor
and let it idle for several minutes. Then with the machine turned off replace the accessory disc and repeat the
start-up operations described above.
