1
2
5.
Close the door and check that the small
door is positioned at the required
height, operating the adjustment screws
if necessary.
6.
Use the same screws for vertical
alignment of the small doors.
7.
If necessary, carry our horizontal
alignment by shifting the small doors.
8.
After aligning the doors, tighten the nuts
of the brackets and the screws of the
small bracket.
9.
Fix the shorter and longer bracket
located under the door to the panel with
the two plastic washers contained in the
box of accessories.
3
1
2
10.
Then refit the bracket cover.
Fitting the plinth
Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make a
cut out as shown.
140-190 mm
170-220 mm
30-100 mm
900 mm
820-870 mm
• If using a plinth higher than 100 mm but
less than 140 mm, cut the height
compensation strip supplied with the
appliance to the required depth and fit it
between the plinth and the ventilation
grille, pressing it into position below this
grille.
• If using a 100 mm plinth, fit the complete
height compensation strip.
17
