6
Technical passporT
english
refrigerator noFF 18769
The fl ammable insulation blowing
gases require special disposal procedure.
Please contact your local authorities
in regard to the environtmentally safe
disposal of this product.
Â
This appliance in not intended for
use by persons (including children) with
reduced physicaI, sensory or mental
capabilites, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
Â
Do not put an ice cube directly
from the freezer compartment into your
mouth.
Â
Моst power failures that are
corrected in an hour and too will not
affect your refrigerator temperatures.
However, you should minimize the
number of door openings while the
power is off. But shuold the power
failure last more than 24hours, remove
all frozen food.
DISPOSAL
INSTALLING THE FRIDGE / FREEZER
1. Allow an adequate space and install
the fridge /freezer on a fi rm, level
fl oor.
Â
If the appliance is not level, there
may be unusual noises and poor cooling.
2. Clean the fridge / Freezer.
Â
Wipe and clean the inside and
outside of appliance with a damp cloth.
3. Plug the fridge / freezer into a wall
socket used exclusively by this
appliance.
Â
This appliance must be properly
earthed.
4. Place the food in the fridge / freezer.
Â
It is recommended that you wait
for the appliance to cool for 3~4 hours
before storing food in it.
5. Keep 50mm of space between the
refrigerator and the back wall.
Â
Insuffi cient space causes the
noise of vibration, weakening of
refrigerating power and the waste of
electricity.
B
Overall space required in use.
Refer to drawing and dimension as
below.
6. The electrical plug must be
accessible without moving the set.
7. For ambient temperature below
10°C, the perfect performance of our
refrigerator can not be achieved.
8. Select a location with level(or nearly
level) and without direct exposure
to sunlight and moisture.
WARNING
Use of an earthed socket exclusively
For the appliance:
Â
If you are using a socket with an
earthed terminal, you do not require a
separate earthed connection.
