26
TECHNICAL PASSPORT
ENGLISH
Built under larder
pluging in 5 – 10 minutes after power is re-
stored.
Â
If you unplug the refrigerator for any
reason you should wait at least 5 min to re-
plug. This will avoid damage to the refrig-
erator’s components.
Â
The cooling unit of your refrigerator
is hidden at the rear of the appliance. There-
fore, water droplets or icing may form on the
rear surface of your fridge due to the opera-
tion of the compressor at specified intervals.
This is normal, there is no need to perform a
defrosting operation unless the icing is ex-
cessive.
Â
If you do not intend to use your
fridge for a long time (e.g. in summer holi-
days), turn the thermostat to the «•» posi
-
tion. After defrosting, clean your fridge and
leave the door open to prevent humidity and
smells.
Â
If the problem persists after you
have followed all the instructions above,
please consult to the nearest Authorised
Service Centre.
Â
The appliance you have purchased is
designed for domestic use and can only be
used at home and for the stated purposes. It
is not suitable for commercial or common
use. If the consumer uses the appliance in
a way that does not comply with this, we
emphasise that the manufacturer and the
dealer will not be responsible for any repair
and failure within the guarantee period.
Tips for saving energy
1.Install the appliance in a cool, well
ventilated room , but not in direct sunlight
and not near a heat source (radiator, cooker..
etc). Otherwise use an insulating plate.
2.Allow warm food and drinks to cool
down outside the appliance.
3.Cover drinks or other liquids when
placing them in the appliance Otherwise
humidity increases in the appliance.
Therefore, the working time gets longer.
Also covering drinks and other liquids helps
to preserve smell and taste.
4.Try to avoid keeping the doors open
for long periods or opening the doors too
frequently as warm air will enter the cabinet
and cause the compressor to switch on
unnecessarily often.
5.Keep the covers of the different
temperature compartments (crisper, chiller
...etc ) closed
6.Door gasket must be clean and pliable.
Replace gaskets if worn.
Please note!
The following shall not be considered as
defects of the Product
Refrigerat
ors
Discoloration of product
materials when using the
product
Noise of flowing coolant during
compressor operation
Minor technical smells of plastic
coming from a new product
Blushing of plastic and aging of
rubber elements of the product
over time
Summary of Contents for VBMR 134
Page 16: ...16 FUR NOTIZEN ...
Page 30: ...30 NOTES ...
Page 46: ...46 ДЛЯ ЗАПИСЕЙ ...
Page 51: ......
