Assembly instructions
Assembly of the barbecue-on-wheels
Install the wheels and depositing
tray at the gripping bow (the ou-
ter one of the two bows).
Mount the depositing tray with
the opening facing to the bottom.
Installation and disassembly of the barbecue
Lift the gripping bow while kee-
ping the stand with the foot.
Engage the bottom deposi-
ting tray in the lateral
cams.
Finally engage the grilling
module in the top lateral
location cams.
To disassemble the
barbecue-on-wheels pro-
ceed in the opposite order.
Additional applications
The grilling module can also be used without wheels
–
as table grill,
–
as warming plate or
–
as cooking/frying plate
(e.g. for fondue).
Note:
If the device has been stored in rooms with an increased air humidity for a
longer period of time (e.g. cellar or garage), water may condense in the de-
vice during commissioning. The condensation water then drops off through
the appropriate openings at the bottom side of the device. Please keep this
in mind when using the device as table grill, warming, cooking or frying pla-
te and put the device onto a suitable base as a precaution.
Electrical connection
The electrical connection is realized by means of a shock-proof plug at a
socket.
Make sure that the connected loads of the household comply with the maxi-
mum voltage of the device (as indicated on the type plate).
If the barbecue shall be used in the open air, we recommend to connect a
high-sensitivity residual-current-operated-circuit-breaker in the incoming
circuit. This type of breaker can be purchased from any electrician.
Please note that the supply connection cable must not contact the hot gril-
ling surface.
Before the first use
Before preparing the first meals clean the grilling surface by means of a
moist cloth and a bit washing-up liquid. Afterwards wipe it dry with a non-
fluffy cloth.
The grilling surface is resistant against thermal shocks (coldness and heat)
and also very robust.
When switching on the grilling surface a short buzzing noise may be heard
from the heating. This is design-specific and has no influence on quality
and operation.
10
GW 30-az GB
