28
INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT
CAUSE
SOLUTION
My accessories and shelf
suppor ts are damaged.
You have not removed the
accessories and suppor ts
during the pyrolytic cleaning
cycle.
You must replace them and
remove them in later cleaning
cycles.
The enamel colour has
changed and stains have
appeared.
The chemical composition of
some foodstuffs may cause
changes in the enamel.
This is normal and does not
damage the proper ties of the
enamel.
The oven door is locked, pilot
light
is lit up but the oven
is not hot.
You have turned the control
dial to position
and no
other additional operation has
been per formed.
Switch off the oven and follow
the instructions to unlock the
door in the first 45 minutes at
a low temperature.
Next, select the pyrolytic
function, carefully following the
instructions.
I have turned the control dial
to position
, pressed the
key, I can see the P1, P2
or P3 on the display but the
pilot light
is not lit up and
the oven is not heating up.
The oven door has not been
closed properly so it cannot
be locked automatically.
Check the door and make
sure that it is closed properly.
I have turned the control dial
to position
, pressed the
key, I can see the P1, P2
or P3 on the display but the
pilot light
is not lit up and
the oven is not heating up.
The door switch is not working
even though the door is
properly closed.
Call Technical Assistance
Ser vice as there is a fault in
the door switch.
