Kuppersbusch IGU1390-1, User Manual

Defrosting the freezer

A certain amount of frost will always form
on the freezer shelves and around the top
compartment.
Defrost the freezer when the frost layer rea-
ches a thickness of about 3-5 mm.
To remove the frost, follow the instructions
below:
1. Turn the Temperature regulator to the

"0" setting and disconnect the mains
plug from the mains socket.

2. Remove any stored food, wrap it in

several layers of newspaper and put it
in a cool place.

3. Leave the door open.
4. Remove the three large drawers.
5. When defrosting is completed, remove

the water that has collected in the small
bottom drawer and dry the interior thor-
oughly.

Insert the plug into the wall socket and turn
the thermostat control to a medium setting.
After let the appliance run for at least two
hours in the "Fast Freeze" mode, replace
the previously removed food into the com-
partments.

Cleaning the air channels

1. Remove the plinth (1), then the ventila-

tion grid (2).

2. Clean the ventilation grid.
3. Pull the air deflector out (3).
4. Clean the lower part of the appliance

with a vacuum cleaner.

3

2

1

Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
1. disconnect the appliance from electrici-

ty supply

2. remove all food
3. defrost and clean the appliance and all

accessories

4. leave the door/doors open to prevent

unpleasant smells.

Important!

 If the cabinet will be kept on,

ask somebody to check it once in a while to
prevent the food inside from spoiling in
case of a power failure.

What to do if…

Warning!

 Before troubleshooting,

disconnect the mains plug from the
mains socket.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.

Important!

 There are some sounds during

normal use (compressor, refrigerant
circulation).

Problem

Possible cause

Solution

The appliance does not
operate. The Pilot light
does not flash.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected
to the mains socket correctly.

Connect the mains plug to the
mains socket correctly.

The appliance has no power.
There is no voltage in the mains
socket.

Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.

16