Fitting the hood
–
Attach the hood to the wall hooks.
–
Align the hood by pushing to left
or right.
–
If necessary, the height at each
wall hook can be altered slightly
with the adjusting screws.
–
Tighten the clamping screws .
–
Tighten the locking screws (C).
Ducting and chimney attachment
After inserting the mains plug, the domestic circuit fuse must be
always removed
–
Remove the transport screws on the chimney sections.
–
Arrange the chimney sections inside one another. For recirculation mode,
the venting slots must be located at the top in the upper section, for ex-
traction mode, they are concealed at the bottom.
–
Recirculation mode only:
Screw
the air deflector firmly to the up-
per chimney section, so that the
deflector openings are in line with
the venting slots. The open side
of the deflector must adjoin the
chimney.
–
The hood and vent opening or air deflector (in recirculation mode) must
be connected via exhaust ducting.
–
Insert the mains plug in the socket.
–
Place the chimney sections in the
hood.
–
Pull out the upper chimney secti-
on and screw to the chimney sup-
port.
–
Fit the lower chimney section to
the hood.
Fitting the grease filters
Before fitting the filters, find the identification plate and make a note of the
serial number and model and enter it on page 15.
Only for appliances in recirculation mode:
–
Place an activated carbon filter in every filter cover and attach it with the
holders. See “Changing the activated carbon filter” on page 6.
All appliances:
–
Push the metal-mesh grease filter
into the slot at the rear and push
up. It will then click into place.
Recirculation mode
Extraction mode
KD 934.1 / KD634.1
17
