11
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T);
+18
°
C and +38
°
C (class ST); +16
°
C and +32
°
C (class
N); +10
°
C and +32
°
C (class SN).
The class of your appliance is shown on its rating plate.
For building into kitchen units follow the special
“Building-in” instructions given.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number
87/308 of 2/6/87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as
these will damage the finish.
Assembly instructions
Fitting the decor panel
(Fig. 1)
Fig. 1
Preliminary
requirement:
the
overall
dimensions of the
decor panel must
be 1-2 mm less
than those of the
door, with a
maximum
thickness of 4 mm.
With the refrigerator door closed, unscrew the
screws securing the removable side piece of the
frame to the door. Remove this side piece and slide
the decor panel into place, after having slackened
the remaining frame screws; push the panel fully
home and secure the frame to the door, including
the side piece previously removed.
Door reversibility
Right hand door opening
Fig. 2
Remove the
upper and lower
screws (1) and
pivots (2) with the
safety washer (4)
on the left side
(Fig. 2). Remove
the door stop
hinge (3-Fig. 3).
Fig. 3
D243
D561
1
2
6
4
5
3
D562
