Küppersbusch IKD6700.0, Instructions For Use And Installation Instructions

on a direct line: about 15 m).
9. Grease filter alarm: After approximately 30 hours of operation, the display will show the symbol 

, indicating that it

is time to clean the grease filters. Once the filters have been cleaned, restart the hour count by pressing the “MENU”
and “ok” (reset) keys at the same time.
10. Charcoal filter alarm: After approximately 120 hours of operation, the display will show the symbol 

, indicating that

it is time to replace the charcoal filters.  Once the filters have been replaced,  restart the hour count by pressing the “MENU”
and “ok” (reset) keys at the same time.

LIST OF SYMBOLS

SPEED (4 speeds  + extra-high speed)

AUTOMATIC SENSOR

19.38

CLOCK

MINUTE COUNTER

In 18°C

INSIDE TEMPERATURE

Out 15°C OUTSIDE TEMPERATURE

GREASE FILTER CLEAN

CHARCOAL FILTER REPLACEMENT

TIMER

ON / OFF

LIGHTS

RESET (COMBINATION OF KEYS)

MENU SELECTION

CONFIRMATION KEY

LESS

MORE

Cleaning the grease filters

: special attention must be given to the grease filters which must be periodically cleaned,

whenever the grease filter alarm trips. For instructions of the filter Alarm, refer  to the Controls paragraph. Remove the
filters as shown in para. 1 and wash with neutral detergent.

Replacing the charcoal filters

: if the filtering version appliance is used, the charcoal filters will have to be periodically

replaced when the charcoal filter alarm trips. For instructions on the filter Alarm, refer to the Controls paragraph. Removing
the charcoal filter/s: first of all, remove the grease filters; push the catch inwards (Fig. 3) and remove the charcoal filter
from its case (Fig. 17). Reposition a new charcoal filter of the same type inverting the operations.

Lighting

: To replace the halogen lamps, open the cover by prising in the slots (Fig. 19). Replace with lamps of

the same type. 

WARNING: Do not touch the new lamp with bare hands.

Inside temperature measuring device

: The hood is supplied with a device for measuring the inside temperature that

can be positioned anywhere in the room. The temperature measured is shown on the hood control panel display. If this
function is not active, use the controls on the hood as follows: press the “MENU” key, then press the - or  + key until
the display shows “In 18°C” or similar; then press “ok”.