Küppersbusch IKE2380-2, User Manual

•

Do not use mechanical devices or other means to accelerate

the defrosting process, other than those recommended by

the manufacturer.

•

Do not damage the refrigerant circuit.

•

Do not use electrical appliances inside the food storage

compartments of the appliance, unless they are of the type

recommended by the manufacturer.

•

Do not use water spray and steam to clean the appliance.

•

Clean the appliance with a moist soft cloth. Only use neutral

detergents. Do not use abrasive products, abrasive cleaning

pads, solvents or metal objects.

•

Do not store explosive substances such as aerosol cans

with a flammable propellant in this appliance.

•

If the supply cord is damaged, it must be replaced by the

manufacturer, its Authorised Service Centre or similarly

qualified persons in order to avoid a hazard.

SAFETY INSTRUCTIONS

Installation

WARNING!

 Only a qualified

person must install this

appliance.

• Remove all the packaging.

• Do not install or use a damaged

appliance.

• Obey the installation instruction supplied

with the appliance.

• Always be careful when you move the

appliance because it is heavy. Always

wear safety gloves.

• Make sure the air can circulate around

the appliance.

• Wait at least 4 hours before connecting

the appliance to the power supply. This

is to allow the oil to flow back in the

compressor.

• Do not install the appliance close to

radiators or cookers, oven or hobs.

• The rear of the appliance must stand

against the wall.

• Do not install the appliance where there

is direct sunlight.

• Do not install this appliance in areas that

are too humid or too colds, such as the

construction appendices, garages or

wine cellars.

• When you move the appliance, lift it by

the front edge to avoid scratching the

floor.

Electrical connection

WARNING!

 Risk of fire and

electrical shock.

• The appliance must be earthed.

• Make sure that the electrical information

on the rating plate agrees with the

power supply. If not, contact an

electrician.

• Always use a correctly installed

shockproof socket.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to the

electrical components (e.g. mains plug,

mains cable, compressor). Contact the

Authorised Service Centre or an

33