17
GB
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
OPERATION
Safety warnings
•
Before carring out any kind of maintenance or cleaning, disconnect the hood from the mains supply.
•
The grease filters and the charcoal filter should be cleaned or replaced as recommended by the manufacturer
or more frequently if the hood is used consistently over 4 hours per day.
•
When using a gas hob in connection with the cooker hood never leave the burners of the hob uncovered while
the hood is in use or when the pans have been removed. Switch off the gas before removing the pan, or for
just short periods and never leave the hob unattended.
•
Always ensure that the flame is kept at the correct intensity to prevent the flame from
licking round from
the bottom of the pan; this will save energy and will avoid a dangerous concentration of heat.
•
Always ensure that the appliance is used in accordance with the manufacturer’s
instructions for the removal of contaminated air and odours during cooking.
Instruction for Use
Control Panel (fig. 9)
The layout of the control panel is as follows:
Button
T1
= Turns the lighting system on and off
Button
T2
= Turns the motor on and off
Button
T3
= Decreases the working speed
Button
T4
= Increases the working speed
Button
T5
= Intensive speed with timed stoppage. Suitable to deal with maximum vapour
emission, this turns off automatically ten minutes after starting operation.
It can be disabled by pressing the button
T5
.Press
T5
for approximately 3
seconds to enable the
Power
function (maximum suction power), which is
indicated by flashing of the LED over the button. This function will be revert
to intensive speed after 5 minutes or when
T5
is pressed again.
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
MAINTENANCE
Constant maintenance guarantees proper operation and longterm reliability. Particular
attention should be paid to the metal grease filters and, for recirculation hoods only, to
the activated charcoal filters. The appliance is equipped with a system that indicates
automatically when it is time to carry out maintenance operations.
Metal grease filters
• Cleaning
These filters must be washed when LED
Filters
starts, or at the most once every 2
months, using a normal household detergent; their compact size also enables them to
be washed in a dishwasher.
• Removing the filters
Remove one filter at a time, pulling and turning the handle in an anticlockwise direction –
see
fig.10
. Replace by repeating the same operations in reverse order, making sure that
the handle is turned to face the outside.
• Enabling the alarm signal
The hood is already set up to trigger an alarm indicating saturation of the metal grease
filters, so this function does not need to be enabled.
• Resetting the alarm signal
To turn the alarm signal off, proceed as follows:
