10
2
ENGLISH |
Table of Contents
Introduction .................................................................................................................3
Setup Instructions......................................................................................................4
Operating Instructions .........................................................................................5-7
DX6 Parts List ...............................................................................................................8
DX6 Mechanical Drawing........................................................................................9
Maintenance Schedule....................................................................................10-12
Troubleshooting Tips ............................................................................................. 13
Vise Data
Use this t
o fill out inf
ormation about your vise for quick reference.
Purchase Date:
_______ -_______- _______
Purchase Order:
_______________________
Purchased From: _______________________
Delivery Date:
_______________________
Serial No.:
_______________________
Note:
Make sure to register your warranty online at kurtworkholding.com
Table of Contents
CAUTION:
Is used when your action or lack of action may cause serious
injury.
OPERATING INSTRUCTIONS
PROPER CHIP GUARD INSTALLATION AND USAGE
Example: Part plus
1.25"
inches = Length of Chip Guard.
Note:
Remove Chip Guard stock
.
I
f left
uncut
,
the excess material
could
cause injury.
CAUTION:
Chip Guard stock shown above is provided to keep chips from
the nut and screw assembly and must be cut and deburred to
meet your application and safety needs.
SURFACE MOUNT USING SINE KEYS
Mounting the new DX8 with keys requires the use of sine keys instead of
standard keys. They are available in several different sizes that are listed
on our website at www.kurtworkholding.com. The keys are sold in sets of
2 per package.
English Mounting:
The DX8 can be properly
located
using the four English sine key holes
indicated by the Y's in figure 5 above. The DX8 vise can also be mounted
using both bolt slots on the sides of the vise.
Metric Mounting:
The DX8 can be properly
located
using the four Metric sine key holes
indicated by the X's in figure 5 above.
Fig.
6
