51
3BA00217 • 2020-10-26 • Rev. 3
Ersa EASY ARM 2
Puesta en servicio
5.
Puesta en servicio
5.1
Volumen de suministro
Compruebe la totalidad y la integridad del contenido del paquete. En caso de componentes
dañados o incompletos se ruega contactar con su proveedor.
El volumen de suministro incluye:
•
Extracción de humos de soldadura EASY ARM 2
• Cable de alimentación
•
Pre-filtro y filtro combinado
• Estas instrucciones de funcionamiento.
5.2
Operaciones previas a la puesta en servicio
■
Saque del embalaje el dispositivo de extracción de humos y quite comple
-
tamente la película protectora.
■
Tome la aspiración en la empuñadura y coloque la misma, junto al supor
-
te de la aspiración, en el lugar deseado.
■
Conecte el dispositivo a la alimentación correcta utilizando el cable de
corriente.
■
Coloque el filtro combinado y el pre-filtro en el aparato (vea el Capítulo 8).
■
Conecte un brazo de extracción apropiado a la boquilla de extracción.
■
Aplique una boquilla apta en dicho brazo.
■
Encienda el dispositivo.
Nota:
En caso de utilizar solo un lado de aspiración, el motor del segundo marcha a
un nivel mínimo a fin de evitar fugas inducidas por presión del aire proceden
-
te de éste.
Summary of Contents for 0CA10-002
Page 90: ...90 3BA00217 2020 10 26 Rev 3 Ersa EASY ARM 2 3 3 1...
Page 91: ...91 3BA00217 2020 10 26 Rev 3 Ersa EASY ARM 2 8 3 2...
Page 93: ...93 3BA00217 2020 10 26 Rev 3 Ersa EASY ARM 2 5 5 1 EASY ARM 2 5 2 8...
Page 96: ...96 3BA00217 2020 10 26 Rev 3 Ersa EASY ARM 2 8 1 8 2 6 8 3...