42
3BA00044-00 • 2013-05-23 • Rev. 4
ersa DIGITAL 2000 A
4.
Starting operation
4.1
Before Commissioning
Please check that the contents of the package are complete. Contents:
• Supply unit
• Mains lead
• Soldering tool with soldering or desoldering tip
• Holder with dry sponge
• These Operating Instructions,
• Safety Information
• With
X-TOOL
:
X-TOOL
Operating Instructions (3BA00023-00)
Should the above components be damaged or incomplete, please contact your supplier.
Important
!
The soldering tip is heated up to 450°C (842°F). Remove any combustible
objects, fluids and gasses from the operating area of the soldering iron.
Do not allow the soldering tip to come into contact with the skin or
sensitive material. When not using the soldering tool, always place it in
the holder.
Observe the following points for safe and
long-lasting use of the soldering tool and
soldering tip:
• Do not strike the soldering iron against hard objects, as the ceramic
heating element is fragile. Do not knock off tin.
• Before using the soldering iron, check whether
the soldering tip is cor
-
rectly mounted (
TECH TOOL
: tighten knurled nut. POWER TOOL: hook
in spring. MICRO TOOL and CHIP TOOL: insert tips up to stop).
• Before soldering, pierce the tip into the dry sponge.
• Do not pierce the tip into the dry sponge after soldering.
• Never use the soldering iron without a tip.
•
Only when using the desoldering pincette:
• Set force limiter, so that the arms do not bend when gripping the
component. Excessive
bending can damage the heating element.
•
Further information see chapter 5.
Starting operation
