43
3BA00044-00 • 2013-05-23 • Rev. 4
ersa DIGITAL 2000 A
4.2
Switching On for the First Time
Please read through these Operating
Instructions completely before commissioning.
Procedure for commissioning:
■
Check whether the mains voltage matches
the value specified on the
nameplate.
■
Set mains switch to 0.
■
Insert mains lead in the mains connection socket at the back of the
device.
■
Put the dry sponge into the sponge container of the holder.
■
Connect soldering tool to the supply unit and place in holder.
■
Insert mains plug in the socket.
■
Switch on device (set mains switch to I).
■
The soldering station is now ready for
operation.
After the display test has been run through (all display elements briefly light up simulta
-
neously), the actual temperature of the soldering tip is
displayed. You can now work with
the soldering station.
4.3
Instructions for soldering
• The soldering joints must always be clean and grease-free.
• Soldering times should be as short as
possible, but the soldering joint
must be sufficiently and uniformly warmed in order to ensure a good
soldering connection.
• Before soldering, lightly pierce the soldering tip into the dry sponge
so that it again has a metallic shine. This helps keep the soldering
joint
from being contaminated by oxidized solder or burnt flux.
• Heat the soldering joint by bringing it in
equal contact with the pad
and component connection.
• Add solder wire (e.g. Ersa Sn95,5Ag3,8Cu0,7 solder wire with flux core
according to EN 29454).
• Repeat soldering procedure.
• From time to time, pierce the soldering tip into the dry sponge. Dirty
soldering tips lengthen soldering times.
• Do not clean the soldering tip after the last soldering operation. The
residual solder
protects the soldering tip from oxidation.
You can receive a detailed process description ‚Fine-Pitch Installation‘ free of charge
upon request from Ersa.
Starting operation
