4
3BA00221 • 2014-09-18 • Rev. 5
ersa i-CON2 & i-CON 2V
2.2
Positioning the soldering station
■
Position the soldering station in a dry location, on a flat surface. Set
the tool holder up next to the soldering station.
■
Before switching it on, make sure the mains voltage matches the value
on the plate.
■
Make sure the soldering iron tip is in the correct position.
■
Turn the soldering station off from the mains switch.
Two soldering irons can be connected to soldering station i-CON 2.
Accordingly, observe the following illustration:
i-CON 2:
i-CON 2V:
i-Tool, Power Tool,
Tech Tool, Micro Tool,
Chip Tool, X-Tool, i-Set Tool
i-Tool
i-Tool, Power Tool, Tech-Tool,
Micro Tool, X-Tool, X-Tool VARIO,
i-Set Tool, Chip Tool, Chip Tool VARIO
i-Tool, X-Tool VARIO,
Chip Tool VARIO
Commissioning
