4 | Transport, installation, storage, disposal
Insert the heating head
4.9 Insert the heating head
a) Push the release lever on the upper side of the heating head on the pin. You
can find the release lever in the accessories box.
Fig. 6:
Use the release lever
b) Place the heating head on both lower supports (see the arrow in the figure on
the left).
Fig. 7:
User the heating head with its suspension bracket
c) Hold the heating head tight with both hands and keep the release lever
pressed with a finger on the top of the heating head. Press the heating head on
the top of the device (see arrow in the figure on the right) until it is locked in
place.
d) No pipette is screwed on the heating head yet. You can find the pipettes in the
accessories box.
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
41 / 157
