6 | Function description
The [Archive] tabulator
Tab [Heater config]: Control of the chart display. If activated during the soldering
process, the displayed chart lines can be selected in the [Show] column.
If for the soldering process in the [Change all zones] function has been switched off,
the single heating phases T1, T2 .... can be clicked on and shown.
– [Device info] tab: Display of basic information about the device and software
versions.
– Tab [Image processing]: Display of image processing settings.
The X button to close the chart is located on the top right of the chart.
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
78 / 157