6 | Function description
Switching off the Rework System
6.15 Switching off the Rework System
ü
To switch off the Rework System:
a) Terminate the HRSoft 2 program by clicking on the red Close button located in
the upper right field.
b) If the HRS file has been edited, you will be asked if you want to save the
changes.
c) Use the main switch to turn off the Rework System.
d) Shut down the PC.
ü
If the Rework system is to be relocated within your company’s premises:
a) Before switching off:
b) Use the joystick on the control unit to move the bottom heating to the middle
and all the way back.
c) Enter tab [Administration] and call up dialog [Device options]. Click on the
[Move to transport position] button.
ð
The heating head is moved to the lowest position.
Do not lift the Rework system by the bottom heating otherwise material damage
will occur!
ü
Before shipping the Rework system,
a) please read Chapter .
b) Use the original packaging for shipping.
ü
After relocating the Rework system, perform two functions:
a) Function [Start device setup]. With regard to this, please read Chapter The
[Start teaching] button.
b) Function [Adjust pixel shift]. With regard to this, please read Chapter The [Pixel
shift adjustment] button.
With regard to this, please also read Chapter Transport, installation, storage, dis-
posal.
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
113 / 157