3 | For your safety
Safety instructions for certain machine and system parts
3.5 Safety instructions for certain machine and system parts
3.5.1 Hot device
CAUTION
Risk of burns from hot surfaces!
a) Touching the device surfaces may cause burns!
All heated machine parts as well as the surrounding housing parts and product sup-
port frame, the circuit board and the components become hot even during warm-
up to the process temperature [Tinit]!
Parts become strongly heated during the soldering process!
3.5.2 Laser equipment
DANGER
Laser beam! Risk of injury due to retinal burns
a) Do not stare into the laser beam!
b) Do not point the laser beam at other people! Reflecting surfaces under the laser
generate reflections!
c) Class 2 laser according to DIN EN 60825-1:2008-5, P < 1 mW, λ = 650 nm
3.5.3 Using a solder fume extractor, plug available
NOTE
Use the soldering fume extraction system!
Solder fumes are hazardous to health. For this reason, a soldering fume extraction sys-
tem should always be used. As regards the type of soldering fume extraction system,
we recommend using the Ersa “Easy Arm” with prefilter, HEPA, particle filter and ac-
tivated carbon filter. The device is equipped with a suitable connection for the solder-
ing fume extraction system. The soldering fume extraction system prevents the device
from accumulating dirt quickly.
3.6 Retrofitting and changes
Any unauthorised alterations and/or changes that may affect the machine safety
are prohibited and relieve the manufacturer / supplier of any liability for any result-
ing damages.
WARNING
Personal injury or property damage and environmental damage caused by the ma-
chine defective condition!
ü
So, please always make sure that retrofitting or modifying the machine does not
pose any problem:
a) Prior to making any changes to the machine, or altering its parameters, contact
the machine manufacturer!
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
27 / 157
