6 | Function description
Temporarily editing the soldering profile in the [Rework] tab
6.5 Temporarily editing the soldering profile in the [Rework] tab
6.5.1 [Rework] tabulator overview
After HRSoft 2 is started, the [Rework] tabulator is displayed. In the [Rework] dialog
you can start and carry out the soldering processes. This dialog is divided into the
following areas:
Combined
Rework
Archive
User administration
Profile management
Administration
Manual mode
Start
Soldering
Desoldering
Name
Placement
Profile settings
Search
Heater config
Information
Board
Component
Control sensor
Adaptor (head)
Lens
pipette
Dip mode
Placement mode
Drop height
IRS
Distance 50 mm
L-head
Pipette 1
No automation
Placement
Heating head
Heating head position
Placement
Inspection
Soldering
Inspection
Desoldering
Soldering Desoldering
Synchronize
Process automation
Fig. 19:
Areas in the tabulator Rework
1 Tabulator bar. To recall the tabulators and the
[Manual mode] button bar
2 Displays and buttons for recalling the dialogs,
from the left to the right:
– Display of the temperature of the relevant
temperature sensor
– Display icon green = Network connection
active; red = No connection
– Button “User name” for changing user
– Button for recalling the [System state] dialog
– Button for closing HRSoft 2.
With regard to this, please read the The display
and button sequence in the right upper corner-
chapter.
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
62 / 157