6 | Function description
Temporarily editing the soldering profile in the [Rework] tab
6.5.4 The chart in the [Rework] tabulator
If the [Profile settings] tabulator is recalled, at the centre of screen the chart (4)
with the heating curves will be displayed, below which the rows and relevant but-
tons for the [Process automation ] (6) will also appear. The heating curves and the
button for [Process automation] may be modified only here.
All changes made in the [Rework] tabulator will be applied but not saved. If you
switch from the [Rework] tabulator to another tabulator, all changes will be lost.
Combined
Rework
Archive
User administration
Profile management
Administration
Manual mode
Start
Soldering
Desoldering
Name
Placement
Profile settings
Search
Heater config
Information
Board
Component
Control sensor
Adaptor (head)
Lens
pipette
Dip mode
Placement mode
Drop height
IRS
Distance 50 mm
L-head
Pipette 1
No automation
Placement
Heating head
Heating head position
Placement
Inspection
Soldering
Inspection
Desoldering
Soldering Desoldering
Synchronize
Process automation
The following buttons are available:
– [Soldering]: In the chart, the blue heating curve for soldering is marked. The
blue heating curve for soldering may be modified and the [Heater config] tabu-
lator may be set for soldering.
– [Desoldering]: In the chart, the red heating curve for unsoldering is marked.
The red heating curve for unsoldering may be modified and the [Heater config]
tabulator may be set for unsoldering.
– [Combined]: In the chart, the heating curves of the soldering and desoldering
temperature are marked. The whole soldering process is displayed. The heating
curves cannot be modified and the [Heater config] tabulator is inaccessible. If
you wish to edit the heating settings configured in the soldering profile, you
should deselect the [Combined] button and select instead the [Soldering] or
[Desoldering] buttons.
– [Synchronize]: It adjusts the unsoldering heating curve to the soldering heating
curve. The two heating curves become coincident. In this configuration, the
changes made to the chart and to the heating settings affect both heating
curves.
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
72 / 157