6 | Function description
Temporarily editing the soldering profile in the [Rework] tab
6.5.5 The [Process Automation] button row
Under the chart there is the [Process automation] (6) button row.
Desoldering
Placement
Inspection
Soldering
Inspection
Process automation
These buttons enable or disable process steps. The process starts with the first pro-
cess step on the left and performs the selected process steps one after the other
on the right.
– [Desoldering]: desoldering a component.
– [Placement]: placing a component in the soldering position. For this, place the
component on the component tray.
– [Inspection]: checking the position of the arranged component with the Re-
work System optical instruments.
– [Soldering]: Soldering a positioned component.
– [Inspection]: Final check of the soldering result with the optical instruments of
the Rework System.
How to perform the soldering process is described by way of example in the Tu-
torial – Soldering or unsoldering a component.
All the changes performed in the [Rework] tab will be accepted but not saved. If
you switch from the [Rework] tab to another tab, all changes will be lost.
The correct soldering profile settings should be specified in the [Profile manage-
ment] tab beforehand. Only possible as “Administrator” user. With regard to this,
please read Chapter The [Process automation] buttons under the [Profile manage-
ment] tabulator [
Ersa GmbH
Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1
75 / 157
