The Effects Chain Editor
Effects Parameters
4-13
Tap n Shapr
adjusts the intensity of the shaper at each output tap. Range is 0.10 to 6.00 x.
Tap n Pitch adjusts the frequency of the comb filter at each output tap. Range is C-1 to C8,
in semitones.
Tap n PtAmt
adjusts the intensity of the comb filter at each output tap. Range is 0 to 100%.
Gated Ducking Delay
This runs the last thing you played through a looping delay, but only outputs the delay signal
when you aren’t playing. Gated Ducking Delay is great for that announcer sound, sound,
sound, so popular in Monster Truck radio spots.
DegenRegen
This one’s a big looping delay with lots of gain, distortion and filtering, and with a
compressor to keep it all under control.
Equalizers (EQ)
The PC4 has both Graphic and Parametric EQ effects. Parametric EQ sections are also found
on a number of combination effects.
The Graphic equalizer is available as stereo (linked parameters for left and right) or dual
mono (independent controls for left and right). It has 10 bandpass filters per channel, each of
whose gain is adjustable from -12 dB to +24 dB.
Like all graphic equalizers, the filter response is not perfectly flat when all gains are set to the
same level (except at 0 dB), but rather has ripple from band to band. To minimize this ripple,
it is best to center the overall settings around 0 dB.
The Parametric equalizer (“5-Band EQ”) has two bands of shelving filters and three bands of
true parametric EQ.
Treb Freq
and Bass Freq set the center frequencies for the shelving filters. Both of these are
adjustable over the full range of 16 to 25088 Hz, in increments of a semitone.
Treb Gain
and Bass Gain control the amount of cut or boost above (Treb) or below (Bass)
the center frequency. The range is -79 to +24 dB.
Midn Gain
sets the cut or boost for the parametric band n, with a range of -79 to +24 dB.
Midn Freq sets the center frequency for parametric band n, with a range of 16 to 25088 Hz,
in increments of a semitone.
Midn Width
set the bandwidth of the filter on band n, with a range of 0.01 to 5 octaves.
Enhancers
Enhancers modify the spectral content of the input signal by boosting existing spectral
content, or stimulating new ones. Two and three-band versions are provided.
Summary of Contents for Flash Play PC4
Page 1: ... It s the sound Part Number 910587 002 Rev B ...
Page 9: ... ix MIDI Implementation A 1 Specifications B 1 Index I 1 ...
Page 289: ... 8 40 ...
Page 328: ... 10 7 ...