Multi Edit Mode
CONTROLS Page
7-16
If the Velocity parameter is set to Per Note, each note in the Key1-Key8 fields will use the
velocity set by each of the 8 per note Velocity parameters.
Key
When the Controller parameter is set to a Key (Key1-Key12) and Mode is set to something
other than “Off” the Key parameter appears.
Use the Key parameter to select which of the PC4’s Keys you wish to use as a switch
controller. With the Key parameter selected, you can set a key by holding the Enter button
and striking the desired key.
Do
When the Controller parameter is set to a Key (Key1-Key12) and Mode is set to something
other than “Off” the Do parameter appears.
The Do parameter determines whether the key will play a note and perform a switch
function, or whether the key will only perform a switch function. Set the Do parameter to
“Both” to play a note and perform a switch function, or set it to “OnlySw” to only perform a
switch function.
Continuous Controllers
This section describes parameters for the following continuous controllers:
• Modulation Wheel
• Pitch Wheel up and down
• CONTROL knobs 1-9
• CONTROL sliders 1-9
• CC pedals 1 and 2
• Pressure
• Ribbon
Controller
Use the Controller field to select a controller for the currently selected Zone.
When the Controller field is selected, you can select a controller by using the ALPHA
WHEEL, PREVIOUS/NEXT buttons, or by holding the ENTER button and moving a
controller.
If a pedal is selected which has a pedal override enabled in Global mode, a message “Global
Pedal Override is enabled” will display when that pedal is viewed to remind you that the
Global mode pedal override settings are being used instead of the Multi mode pedal settings.
Summary of Contents for Flash Play PC4
Page 1: ... It s the sound Part Number 910587 002 Rev B ...
Page 9: ... ix MIDI Implementation A 1 Specifications B 1 Index I 1 ...
Page 289: ... 8 40 ...
Page 328: ... 10 7 ...
