Program Edit Mode
KB3 Editor: The Drawbars (DRAWBR) Page
7-88
In both modes, the drawbar volume settings will immediately change as soon as you move a
corresponding slider.
Steps
This parameter lets you specify the increments by which drawbar volumes will change.
Choose either 0–8, to approximate the drawbar settings on actual organs, or choose 0–127
for a finer degree of resolution.
Volume
This parameter appears only if you’ve set Mode (see above) to Preset. Use the Volume
parameter to set the preset volume of each of the nine drawbars. The available values will be
0–8
or 0–127, depending on the setting of the Steps parameter.
Tune
This parameter lets you tune each of the nine drawbars up or down in semitone steps. The
values for the Tune parameter on the DRAWBR page shown above represent standard
drawbar settings on a real B3, as shown in the table below.
Subharmonics
Fundamental
Harmonics
16’
5
1
/3’
8’
4’
2
2
/3’
2’
1
3
/5’
1
1
/3’
1’
Slider A
Slider B
Slider C
Slider D
Slider E
Slider F
Slider G
Slider H
Slider I
Figure 7-2 Standard Drawbar Settings for the Hammond B3
