Multi Edit Mode
ARP1 and ARP2 (Arpeggiator 1 & 2) Pages
11-29
FX Page
The Forte SE contains Kurzweil’s acclaimed effects processor, and when combined with Multi
Mode it puts the power of an entire studio of audio effects at your fingertips. This section
contains everything you’ll need to know in order to use the Forte SE’s effects in Multi Mode.
Press the FX soft button to enter the FX page.
Parameter
Range Of Values
Default Value
Allocate FX
Y, N, (Y)
Y
Program Insert
Effects Chain List (Appendix F)
Program dependent
Allocate FX per channel
Use the Allocate parameter to enable or disable the Insert and Aux effects Chains of the
Program in each MIDI channel. (The MIDI channel for each Zone can be set on the Zone
Main page.) Each MIDI channel can be set to Y to enable effects, or to N to disable effects.
Use the Alpha Wheel or Value buttons to change between Y and N. Some MIDI channels set
to Y may be displayed as (Y). This means that there are not enough effects resources available
for that channel, and that channel’s effects are not loaded. If you want to use the Chains for a
channel displayed as (Y), try setting other channels to N.
Program Insert (Prog. Insert)
When each channel is selected, the Prog Insert field shows the name of the Insert Effects
Chain used by the selected channel. The Chain can be enabled or disabled using the “Allocate
FX per channel” section of the page. To edit or select a different Insert Effects Chain, the
Program must be edited in Program Edit mode.
