Program Edit Mode
The Layer FX (LYR_FX) Page
7-16
main Insert Output to Sec.—keep in mind that by this method, the dry signal is sent to the
auxiliary audio outputs.
When Type is set to %, the Aux Send parameter values are in units of percent (%). The
value specified in the Aux Send parameter is the percentage of which the wet auxiliary signal
comprises the final signal—the insert signal comprises the rest of the final signal. To hear
equal parts wet signal and dry signal on the main audio output, set the main Insert effect to 0
None and the Insert Output to Main, and set the Aux 1 effect to your desired effect and the
Aux 1 Output to Main. Then, set the Aux1 Send to 50%. If you want to hear only the wet
signal, set the Aux1 Send to 100%.
Aux1 Mod, Aux2 Mod
The Aux Mod parameter gives you real-time control over the amount of program signal sent
to the aux effects chain. You can set the Aux Mod parameter to any Forte SE control source.
The amount that you specify for the Aux Send parameter is the maximum value that the Aux
Mod control source can send—the minimum value is 0.
The Layer FX (LYR_FX) Page
Press the LYR_FX soft button to call up the Layer FX (LYR_FX) page. On this page, you can
apply layer-specific effects. There are three Layer FX Modes: Use Program FX, Layer-Specific
FX, and Use Another Layer’s FX.
Use Program FX Mode
With Use Program FX Mode selected, the current layer will use the effects configured on the
Program FX (FX) page. See
The Program FX (FX) Page on page 7-14
for more information
on program FX.
Layer-Specific FX Mode
With Layer-Specific FX selected, you can configure the effects for the current layer. This
mode’s parameters are similar to those of the FX page. This mode is shown in the following
display:
