Global Mode
MAIN Page
12-4
Power Off Time
If the Auto Power Off parameter is set to On, then the Forte SE will power off after the
time selected by the Power Off Time parameter has elapsed. The Forte SE will display the
following warnings before powering off. Press a key or move any Forte SE control to dismiss
the warning message. After dismissing this message, the Forte SE will wait the selected
amount of time before showing this warning again.
Out Clock
To send a MIDI clock pulse to the MIDI Out port, set this parameter to On. Otherwise, set
it to Off.
Clock Source
With the Clock Source parameter set to Internal, Forte SE plays using its own Tempo. If you
wish to sync the Forte SE to the tempo of an external device, use the External setting.
ProgTempo
The ProgTempo parameter is shown when the User Type parameter is set to Advanced.
The ProgTempo parameter determines whether each program in Program Mode will use
its own tempo, or if each program will use the Global Mode System Tempo. A setting of
“Program” will use the tempo from each program, and a setting of “System” will use the
Global Mode System Tempo. When the User Type parameter is set to “Regular”, program
tempo will be used.
In Program Mode, tempo controls the rate of each Program’s arpeggiator, as well as the
rate of any tempo synced Insert or Aux effects that each program may use. In Multi Mode,
program tempos are ignored and the Multi Common Tempo of each Multi is used for all
programs in a Multi.
For details on setting a tempo for each program, see
. When the Global
Mode ProgTempo parameter is set to “Program”, programs can still use the System tempo by
setting Tempo to “System” on the Program Edit Prog Arpeggiator page.
