Program Mode
The Split and Layer Functions
6-11
Split Function
When you create a Split in Program Mode, you are creating a Multi with two active Zones.
The Program you were using in Program Mode is used in the right hand of the Split as the
Program for Zone 1. After this you can choose a Program that will be used in the left hand of
the Split as the Program for Zone 2.
The default Program parameter for a Split is 210 P-Bass, and the default keyboard range is
C1 - E3. These may be changed, as described below.
Other parameters that determine the behavior of the Split are described in
. Use the navigation buttons to access each of the Split/Layer
parameters.
Once you have saved your Split as a Multi, you can continue to add Split or Layer Zones to
the Multi until you reach the maximum number of active Zones. See below for details on
saving.
