MIDI Mode
The Channels Page
10-9
Volume
This sets the volume for any program assigned to the currently selected channel. A value of 0 is
silence, and a value of 127 is full volume. The value of this parameter will change in response to
MIDI Volume (MIDI 07) messages, unless the VolLock parameter (described below) is set to On.
Output Pair (OutPair)
This parameter sets the audio output group for the program assigned to the currently selected
channel. The default value of Prog means that the output group is determined by the program’s
value for the Pair parameter on the OUTPUT page in the Program Editor. In this case, the
channel’s output group will change depending on the program assigned to it, with the output
group being routed on a per layer basis within the program. Values of A B, C, or D fix the
output group regardless of the program that’s assigned to the channel.
Output Gain (OutGain)
OutGain will boost or cut the level at the audio outputs for any program assigned to the
currently selected channel. This allows you to make a program louder or softer without having
to edit the program.
Parameter Locks
Program (PrgLock), Pan (PanLock), Volume (VolLock)
When the parameter locks are set to On, the three parameters they control will not respond to
their respective MIDI controller messages. In that case, you could change the Program, Pan,
and Volume settings from the front panel, but not via MIDI.
