2
SETTING UP AND CARING
FOR YOUR
MicroPiano
See the
ÒImportant Safety and Installation
InstructionsÓ
on the inside front cover for
important information as you set up and
turn on your
MicroPiano
.
Never take apart your
MicroPiano
. There
are no user-serviceable parts inside.
Clean your
MicroPiano
with a soft, dry cloth.
Do not
use aerosol sprays on or near the
MicroPiano
.
Mounting Your
MicroPiano
to a Half-Rack Adapter
The
MicroPiano
is a single-space, half-rack
module designed to Þt securely into any standard
19" equipment rack. For safety, do not turn on the
power source for other devices in your MIDI
system until the
MicroPiano
is connected.
If you desire to mount the
MicroPiano
in
your current equipment rack, Kurzweil recom-
mends you purchase a standard half-rack adapter
from your local dealer.
Enclosed with the
MicroPiano
are four screws
and four small adhesive-backed rubber feet for
mounting the unit to any half-rack adapter. Attach
the rubber feet as shown in the diagram on the
next page. The feet are required to be attached to
the
MicroPiano
, whether you mount it in a half-
rack adapter or sit it on a table.
To mount the
MicroPiano
to a half-rack
adapter, you must use the screws supplied. The
four holes in the bottom of the
MicroPiano
are
positioned such that they should line up with at
least two mounting holes in most standard
adapters.
See the illustration on the next page for more
mounting information.
Be sure to USE THE
SCREWS THAT COME
WITH THE UNIT.
They are
3/8
" in length
and intended for use in
conjunction with the
rubber feet. If these
screws are misplaced,
do not substitute with
screws that are longer than
3/8
"
in length
. If the screws
are longer than that, they
will hit electronic com-
ponents within the
MicroPiano
and very
likely damage it.
