2-8
Startup
Powering Up
No Sound from Receiving Instrument
If you are trying to control another instrument using MIDI and that instrument doesnÕt respond
to your PC2, check the following:
¥
A working MIDI cable should connect the PC2Õs Out or Thru/Out jack to the In jack of the
other instrument
¥
If youÕre using the MIDI Thru/Out port, ßip the switch near the MIDI In port to the out
position (a ball-point pen works well for this)
¥
Continuous control pedal 1: check the connection and pedal position
¥
The other instrument should be receiving on the same MIDI channel that the PC2 is using to
transmit MIDI information
¥
All zones that you want to transmit must be active (the lights in the
Zone 1
Ð
Zone 4
buttons
must be green)
¥
The PC2 might be sending MIDI information only to itself: press the
MIDI Xmit
button in
the Zone Parameters region of the front panel, then press the right-arrow button under the
display once, then turn the large knob in the Data Entry region until you see
MIDI
or
Local+MIDI