4-14
Programming Your PC2
The Setup Editor
The top line indicates the current zone, as well as the current bank and program ID.
Notice the minus sign after the zone number, indicating that the zone is muted.
5. Turn the Alpha Wheel to the left until you see
Off
in the bottom line of the display. Notice
that the
Zone 3
button is now unlit, indicating that the zone is off.
6. Repeat Steps 4 and 5 for Zone 4. You now have a two-zone setup (the setup still has four
zones, but two of them are completely inactive).
7. Press the
Zone 1
button to make Zone 1 the current zone.
8. Press the
Program
button, and you should see
000|Stereo|Grand
on the bottom line of
the display. If you donÕt, select it using your favorite data entry method.
9. Press the
Zone 2
button to make Zone 2 the current zone. Press it again to unmute it.
10. Select the program
064 Lyrical Strings
.
11. Press
Store
to display the Save dialog:
Save|Setup|129?
A01|Default|Setup
Notice that the PC2 suggests a setup ID of
129
, which is the Þrst unused setup ID in the
User bank. WeÕll use that ID, but weÕll rename the setup before storing it.
12. Press
>
, and the display prompts you to rename the setup. Press
Yes
.
13. Press
SW2
repeatedly until youÕve erased the entire name (this is optional; you can also
write over each existing character in turn, if you prefer).
14. Enter a name that you can remember, because weÕll refer to it in later examples. Use the
alphanumeric buttonpad and the
>
button to select characters and move the cursor. WeÕll
call this setup
Piano&Strings
. Refer to
Naming and Storing
on page 4-2 if you need a
reminder about naming objects.
You can get to the
&
character by pressing the
Plus
button under the Alpha Wheel six
times when the cursor is highlighting a blank character space.
15. When youÕve entered the name, press
Yes
. The Save prompt returns. Press
Yes
again to
save the setup.
Setting Initial Volume Levels for Different Zones
Suppose you want the program in one zone of a setup to be at a lower volume than the others.
WeÕll edit our two-zone setup to lower the volume of the strings.
1. Start with Setup
129 Piano&Strings
, which we created in the previous example.
2. Press the
Controllers
button. The display probably looks like this:
Zone:2|||||||||0:064
Entry|Volume:|127
3. Press
7
,
5
, then
Enter
.
