Programming Your PC2
The Setup Editor
4-15
4. Play a few notes. If you donÕt hear a difference, press
Compare
and play some more. Press
Compare
again to stop its LED from blinking.
5. Press
Store
to display the Save dialog. Notice that the display prompts you to replace
Setup
129
. We donÕt want to do this.
6. Press the
Plus
button, and the display will prompt you to save Setup
130
.
7. Rename the setup as
EntryVol
, and save it at ID
130
.
Assigning Sliders to Control Wet/Dry Mix in Different Zones
1. Start with Setup
130 EntryVol
, which we created in the previous example.
2. If Zone 1 isnÕt the current zone, press the
Zone 1
button to make it current.
3. Press and hold the
Controllers
button and move Slider
A
. The display looks like this:
Zone:1||||||Slider|A
Ctrl|Num:|None|
4. On the alphanumeric button pad, press
9
, then
3
, then
Enter
. This assigns Slider
A
to send
FXAWet. (MIDI Controller 93), which controls the wet/dry mix for the FX-A effect block.
5. Press the
Zone 2
button to make Zone 2 the current zone.
6. Press and hold the
Controllers
button and move Slider
B
.
7. Press
9
,
1
, E
nter
to assign Slider
B
to send FXBWet (MIDI 91).
8. Play the keyboard and move the two sliders. You should hear the level of the effects (a
chorus controlled by Slider
A
and a reverb controlled by Slider
B
) change as you move the
sliders.
9. Save the setup as
131 SliderFX
.
Assigning Entry Values
Suppose you have a setup with an effect whose wet/dry mix is controlled by a slider. You want
to make sure itÕs active when you start playing the setup. Entry values are a convenient way to
specify initial settings for any controller. WeÕll edit
SliderFX
, and set an entry level for Slider
A
in Zone 1 so that the wet/dry mix of the chorus is at about 75% as soon as we select the setup.
1. Start with Setup
131 SliderFX
. Make Zone 1 active, if it isnÕt already.
2. Make sure that the send for FX-A is active. If the FX-A button isnÕt lit, press it. In fact, letÕs
make sure that both effect sends are active when we select the setup.
3. Press
FX-A
and
FX-B
simultaneously. Both LEDs should be lit.
4. Press
Store
. YouÕll see a prompt asking if you want to replace Setup
131
. Press
Yes
. YouÕve
saved the effect-send settings as part of the setup. Now letÕs set the entry value for
Slider A in Zone 1.
5. Press and hold the
Controllers
button and move Slider
A
. YouÕll see the Ctrl Num
parameter for Slider
A
in Zone 1.
