6-60
Program Mode
The KEYCLK Page
KeyClick
This is where you turn Key Click on or off.
Volume
This parameter sets the level of the keyclick; the noise decays from the level you set here. This
level is scaled by the drawbar levels, as well as the expression pedal level.
Decay
Sets the basic decay time of the noise envelope. Smaller values produce a shorter burst.
VelTrk
Controls the degree to which key velocity affects the key click volume. A value of zero means
that the key velocity has no effect on the key click volume (which is like a real tone wheel organ).
Other values add volume as the velocity increases.
Random
Controls the degree to which a random amount of amplitude variation is added to the key click.
ReTrigThresh
This parameter lets you set the volume level below which key click must decay before it will be
retriggered.
Note Attack
Controls the attack characteristic of notes.
Normal
provides a smoothed attack, while a setting
of
Hard
has an instant attack and will produce an audible click, in addition to any amount of
key click specified with the other parameters on this page (you might prefer not to specify any
additional key click when you use this setting).
PercHard
sets a hard attack level for percussion
only; notes without percussion use a normal attack.
Note Release
Controls the release characteristic of notes. A setting of
Normal
has a smoothed release, while a
setting of
Hard
has an instant release.
Hard
will produce an audible click.
Random
0 to 100%
Retrigger Threshold
-96.0 to 0.0 dB, in 0.5-dB increments
Note Attack
Normal, Hard, PercHard
Note Release
Normal, Hard
Parameter
Range of Values
Summary of Contents for PC3
