6-62
Program Mode
The MISC Page
LeakMode
Selects between different leakage models, determining which leakage harmonics are
emphasized.
TypeA
provides an overall tone wheel leakage, with all tone wheels leaking a small
amount.
TypeX
,
TypeY
, and
TypeZ
emulate different degrees of drawbar leakage, where the
leakage components correspond to the nine drawbars, instead of all the tone wheels.
SpeedCtl
Select either
Fast
or
Slow
to choose the speed of the rotary speaker emulation. On keyboard
models, you can toggle between fast and slow speed using Assignable Controller Button
1
(
Mute
button
1
).
When you select a KB3 program, the PC3 sends several MIDI Controller messages both locally
and to the MIDI Out port. One of those messages is Controller number 68, with a value
corresponding to the value of SpeedCtl (
Slow
= 0,
Fast
= 127).
VibChorCtl
Choose
On
or
Off
to turn on or off either vibrato or chorus (as selected with the VibChorSel
parameter). On keyboard models, you can toggle between on and off using Assignable
Controller Button
2
(
Mute
button
2
).
When you select a KB3 program, the PC3 sends several MIDI Controller messages both locally
and to the MIDI Out port. One of those messages is Controller number 95, with a value
corresponding to the value of VibChorCtl (
Off
= 0,
On
= 127).
VibChorSel
Choose the vibrato or chorus program (there are three of each) you wish to use with this KB3
program. Note that you must set VibChorCtl (also on the MISC page) to
On
to hear the effect.
On keyboard models, you can select the vibrato or chorus you want using Assignable Controller
Buttons
3
and
4
(
Mute
buttons
3
and
4
.
When you select a KB3 program, the PC3 sends several MIDI Controller messages both locally
and to the MIDI Out port. One of those messages is Controller number 93, with a value
corresponding to the value of VibChorSel (
Vib1
= 0,
Vib2
= 36,
Vib3
= 58,
Chor1
= 79,
Chor2
= 100, and
Chor3
= 122).
VolAdjust
Provides an overall volume adjust for the KB3 model. Use this parameter to “normalize” KB3
programs with other programs.
BendRngUp, BendRngDn
Respectively control the upward and downward pitch bend ranges of the KB3 program.
Sustain
Set
On
or
Off
to enable or disable response to MIDI sustain (MIDI 64).
Sostenuto
Set
On
or
Off
to enable or disable response to MIDI sostenuto (MIDI 66).
Summary of Contents for PC3
