7-40
Setup Mode
The Ribbon Configuration (RIBCFG) Page
field to MIDI22, the parameter will automatically also use MIDI54 as a source, enabling the 768 step
resolution when using the one section ribbon. The additional source that is automatically used will not be
seen in the Program Editor (this happens behind the scenes,) but both CC numbers will be sent to the MIDI
Out and USB port. (Also note, MIDI32 through MIDI63 are not available in the Program parameter
source fields, as they are reserved for using CC numbers 0-31 as described above.) When the ribbon is used
as a one section controller, if a MIDI CC above 63 is used as the destination for Sect1, only one CC number
will be sent and the ribbon will have a resolution of 128 steps. When the ribbon is used as a three section
controller, each section will only send one CC number and each section will have a resolution of 128 steps.
The Ribbon Configuration (RIBCFG) Page
Once you’ve selected a destination for the optional Ribbon controller, you can use the parameters
on
the RIBCFG page to define how the ribbons respond to finger position and pressure.
Parameter
Range of Values
Default
Ribbon Configuration
One Section, Three Sections
One Section
Position Mode
Relative, Absolute
Relative
Spring
On, Off
On
Center
0 to 127
64
Ribbon Configuration
You can use the Ribbon as one controller, or divide it up into three smaller sections, each with its
own controller assignments. Choose a value of
One Section
or
Three Sections
for the Ribbon
Configuration parameter. With
Three Sections
chosen, the page changes such that you can
adjust the parameters of each section:
