19
3. Resistance measurement
1) Turn on the power.
2) There are two ways for resistance input:
a. Insert the resistance to be measured into the input
terminal directly (shown in figure-12);
b. Connect the alligator clips to the ends of the
to be measured (shown in figure-13).
resistance
7) Press
FUNC.
key four times to select DCR mode.
The primary LCD display will show the resistance
value. The secondary parameter is omitted and
the
D/Q/ESR
key,
SEL/PAL
key and
FREQ
key
are not available.
6) Press
SER / PAL
key to select series or parallel
mode.
5) Press
FREQ
key to select frequency value:
100/120 /1K/10K/100KHz.
4) Press
FUNC.
key three times to select Auto-R
(ACR) mode, The primary LCD display will
show the resistance value. The secondary
parameter is omitted and the
D/Q/ESR
key. is not
available.
3) The default test mode is Auto LCR mode, the
resistance value will be shown on primary display
and the phase angle
q
will be shown on
secondary display. In Auto LCR mode, the
D/Q/
ESR
key,
SEL/PAL
key,
SORTING
key and
REL
%
key are not available
20
GUARD
GUARD
INPUT
Rx Lx Cx
L
CUR
L
POT
H
POT
H
CUR
GUARD
GUARD
INPUT
Rx Lx Cx
L
CUR
L
POT
H
POT
H
CUR
Figure 12
Figure 13
1) Connect the AC power cord to the AC-DC
converter
2) Plug the AC power cord into an electrical outlet
(100V-240V).
3) Plug the DC power plug of the convertor into DC
power socket of the meter
DC power
Socket
DC power
Plug
AC-DC
AC power
Cord
Converter.
AC/DC adapter information:
Input : 100V-240VAC, 50-60Hz 1.8A
Output : DC 12V 2A MAX
Polarity :
+
-
To use Adapter
(Under external power adapter,
the automatic power off function is not available).
Connecting the power adapter:
Note :
The phase angle
q
will show on secondary
display only in Auto-LCR mode. During
Auto-R mode or DCR mode, the secondary
parameter is not available.
