9
NO. MEANING
NO. MEANING
1
2
3
4
5
6
7
8
9
10
Auto power off indication
Data hold
Auto mode indication
Auto LCR mode indication
Range indication
Relative Measurement mode
Main-display
Unit for main parameters
Secondary parameters
Unit for secondary parameters
11
12
13
14
15
16
17
18
19
20
Sub-display
Analog bar indication
The meter is in the data transmission mode.
battery indication (with battery supply)
Frequency indication
Tolerance range
Sorting mode indication
External power supply
Open/Short calibration mode indication
Primary parameters
Operating instruction
Power on the meter
Press key to turn ON the power. The default mode is
AUTO LCR smart mode and the default test frequency
is 1kHz. When key is pressed during power-on
mode, the instrument will enter power-off mode. The
LCD will show the "OFF" state before power off.
Function Descriptions
Press
FUNC.
key to select the following parameters
sequentially : AUTO LCR, L-Q, C-D, R, DCR.
1) Parameters setting
Parameter
MEANING
AUTO-LCR
L-Q
Auto LCR smart mode
Inductance measurement, the parameter
on sub-display is quality factor Q
C-D
Capacitance measurement, the parameter
on sub-display is dissipation factor D.
R
Resistance measurement
DCR
DC resistance measurement mode
L/C/R measurement readings can be positive or
negative. In C-D measurement, If the main parameter
is "-", the actual component being tested is inductive;
In L - Q measurement, if the main parameter is "-", the
actual component being tested is capacitive;
Theoretically, R is positive, in some cases, R is "-",
which may be calibration error, please re-calibrate the
instrument.
2. Auto LCR smart Mode
The default test mode is Auto LCR mode which could
check the type of impedance smartly.
If I
q
I < 11°, the Auto - R mode is selected. The
parameter on sub - display is
q
.
If
q
> 11°, the Auto - L mode is selected. The
parameter on sub - display is Q.
If
q
< -11°, the Auto - C mode is selected. The
parameter on sub - display is D.
If the C < 5pF, the parameter on sub-display is parallel
resistance Rp.
Note : In order to avoid damaging the instrument,
the capacitance requires discharge before
measuring.
3. Frequency setting
Press
FREQ
key to select frequency value : 100/120/
1K/10K/100KHz. The LCR impedance scale ranges
are depended on the test frequency.
4. Data Hold
Press this key to hold the measurement data and
press it again to resume the measurement.
10
