“KUSAM-MECO”
AN ISO 9001:2015 COMPANY
“KUSAM-MECO”
AN ISO 9001:2015 COMPANY
29
Auto-Power off (APO)
The Auto-Power-off (APO) mode turns the meter off automatically
to extend battery life after approximately 30 minutes of no
activities. Activities are specified as :
Disabling Auto-Power off
Press the
SELECT
button while turning the meter on to
temporarily disable the Auto-Power-Off feature. Turn the rotary
switch OFF and then back on to resume.
Manual or Auto-ranging
Press the
RANGE
button momentarily to select manual-ranging,
and the meter will remain in the range it was in, the LCD
AUTO
turns off. Press the button momentarily again to step through the
ranges. Press and hold the button for 1 second or more to
resume auto-ranging.
Set Beeper Off
Press the
RANGE
button while turning the meter on to
temporarily disable the Beeper feature. Turn the rotary switch
OFF and then back on to resume.
Note : Manual ranging feature is not available in Hz function.
1) Rotary switch or push button operations, and 2) Significant
measuring readings of above 512 counts or non-OL
W
readings.
In other words, the meter will intelligently avoid entering the APO
mode when it is under normal measurements. To wake up the
meter from APO, press the
SELECT, RANGE, RELATIVE or
HOLD
button momentarily or turn the rotary switch OFF and then
back on. Always turn the rotary switch to the OFF position when
the meter is not in use.
30
Data Logging operation
1) Set logging interval
(Up-arrow)
or
(Down-arrow)
button momentarily to
select a different sampling speed from 0.05s (0.1s for
single T1/T2, Diode & W/nS; 0.5s for Hz/Duty; 2s for Cx &
dual T1 +T2 / T1-T2 +T2), 0.1s, 0.5s, 1s, 2s, 3s, 4s, 5s, 10s,
15s, 30s, 60s, 120s, 180s, 300s, up to the slowest 600s.
Then press the
(Timer)
button for 1 second or more to
confirm the new setting.
Press the
(Timer)
button for 1 second or more to display
the selected sampling speed in second. Factory default
0.05 means sampling speed is 0.05 second. Press the
5
6
¹
¹
