INSTALLATION INSTRUCTIONS
I. INSTALLATION
1. Follow instructions for installing the Auto Eject.
2. Place the template in position and center punch in 6 places, see Figure 1: Hole Template.
3. Drill 4 mounting holes, 3/16” diameter, one 1-3/4” clearance hole for the Super Auto Eject, and
one 13/32 hole for the indicator wiring cable.
II. HOLE TEMPLATE: Figure 1
Note:
When printing this page use the print setting “Actual Size”, otherwise template may not print
to scale.
INTRODUCTION
The new Super Auto Eject Deluxe Cover incorporates two products into one easy to install package.
The Deluxe Cover features a remotely mounted volts and amps digital display. Two 3-digit LED dis-
plays are used to display the Kussmaul battery charger output voltage and current. Two individual
LEDs are used to provide additional battery charger status such as: HIGH voltage, LOW voltage,
current-limit, and over-current.
The new lid design provides for 180-degree motion. This all-in-one package can be easily installed
into existing and new Auto Eject installs.
2
FEATURES
I. NEW COVER DESIGN
• Incorporates Auto Eject cover and Digital Display into one product
• Lid on cover opens 180-degrees to prevent beakage
• Two numerical LEDs display Auto Charger Volts and Amps output
• Includes rear mounted premolded rubber gasket for extra protect from the elements
II. INCORPORATED LED NUMERICAL DISPLAYS
When used with Kussmaul Auto Charger, two numerical LED displays output the chargers voltage
and ampage. These easy to read displays provide immediate charger output conditions.
III. VOLTS & AMPS LED STATUS INDICATOR
VOLTS LED:
• Blinking RED: HIGH voltage or LOW voltage condition
• Blinking GRN: Charging
• Solid GRN: Charged
AMPS LED:
• Blinking RED: Current-limit exceeded
• Solid RED: Current-limit
• Solid GRN: Output greater than 5 amps
