SYSTEM OPERATION
5
8.
Output Update Rate: The DRU III can be set to
output packets of speed data at rates of (8 times per
second, 4 times a second, 2 times a second, once a
second, upon speed change, or when the user’s
equipment polls for data)
Note: If Output Update Rate is set to upon speed
change, the DRU III outputs speeds immediately
when the speeds changes by at least one unit or once
every two seconds if the speed is not changing.
If the DRU III is set to the Polled output, data is
output when the DRU III receives characters [“*P”]
or [“*P”0x0D].
9.
During the configuration session, the Status box will
display information about the connected DRU III and
the status of the configuration operations.
To configure your DRU III unit, connect the DRU III data
connector to the PC comm. port 1 and apply power to the
DRU III. Click the Reset & Capture button to capture the
DRU III for configuration. You can click the Read Settings
button to populate the configuration screen with the current
DRU III settings. Make any required changes in the
configuration options and click the Write Settings to store
these changes in the DRU III. When finished, click the
Release button to return the DRU III to normal operation
with the new configuration settings.
Summary of Contents for DRU III
