background image

 

 Model     Power    Equalizer    Channels   Impedance    Effects             Amplifier Type                Dimensions          Weight

 KBA30     30 W

   5 Band         One          8 Ohms         N/A           MOS-FET Transistor         15.25”x8.5”x13”       38 lbs.

                                                                                                                                                 38x45x31 cm.        15.4 kg.

SPECIFICATIONS

THIS APPARATUS SHALL NOT BE EXPOSED TO

DRIPPING OR SPLASHING. NO OBJECTS FILLED

WITH LIQUIDS SUCH AS VASES SHALL BE PLACED

ON THE APPARATUS.

TO AVOID ELECTRICAL SHOCK, DO NOT

DISASSEMBLE. REFER SERVICING TO QUALIFIED

PERSONAL ONLY!

Kustom Inc., 4940 Delhi Pike, Cincinnati, OH • USA

(800) 999-5558  Fax: (513) 347-2192 / www.kustom.com

SOUND LEVEL db FLOW RESPONSE

90

93

95

97

100

103

  110

                             CAUTION

THIS AMPLIFIER HAS BEEN DESIGNED AND CONSTRUCTED TO PROVIDE

ADEQUATE POWER RESERVE FOR PLAYING MODERN MUSIC WHICH MAY

REQUIRE OCCASIONAL PEAK POWER. EXTENDED OPERATION AT

ABSOLUTE MAXIMUM POWER IS NOT RECOMMENDED SINCE THIS

COULD DAMAGE THE ASSOCIATED LOUDSPEAKER SYSTEM. PLEASE BE

AWARE THAT MAXIMUM POWER CAN BE OBTAINED WITH VERY LOW

SETTINGS OF THE MASTER VOLUME CONTROLS IF THE INPUT SIGNAL

IS VERY STRONG.

IMPORTANT

1.  Read all safety and operating instructions before using this product.

2.  All safety and operating instructions should be kept for future reference.
3.  Obey all cautions in the operating instructions and on the back of the unit.
4.  All operating instructions should be followed.
5.  This product should not be used near water i.e. bathtub, sink, swimming

      pool, wet basement, etc.
6. This product should be located so that its position does not interfere

      with proper ventilation. It should not be placed flat against a wall or

      placed in a built-in enclosure that will impede the flow of cooling air.
7.  This product should not be placed near a source of heat, such as a 
 stove, radiator, or another heat  producing amplifier.
8. Connect only to a power supply of the type indicated on the back of the

      amplifier near the power supply cord.
9. Do not break off the ground pin of the power supply cord.

10. Power supply cords should always handled carefully. Never walk or place
      equipment on power supply cords. Periodically check cords for cuts or

      signs of stress, especially at the point where the cord exits the unit.
11. The power supply cord should be unplugged when the unit is unused

for long periods of time.

12. If this product is to be mounted in an equipment rack, rear support

 should be provided.

13. Metal parts and vinyl covering may be cleaned with a damp rag.
14. Care should be taken so that objects do not fall and liquids are not spilled

  into the unit through the ventilation ports or any other openings.

15.This unit should be checked by a qualified service technician if:

A. The power supply cord or plug has been damaged.

B. Anything has fallen or been spilled into the unit.
C. The unit does not operate correctly.

D. The unit has been dropped or the enclosure damaged.

16. The user should not attempt to service this equipment. All service work

      must be done by a qualified service technician for warranty repairs.

                                                       DANGER

EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT

HEARING LOSS. INDIVIDUALS VARY CONSIDERABLY TO NOISE INDUCED HEARING

LOSS BUT NEARLY EVERYONE WILL LOSE SOME HEARING IF EXPOSED TO

SUFFICIENTLY INTENSE NOISE FOR A SUFFICIENT TIME.

THE U.S. GOVERNMENT'S OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION

(OSHA) HAS SPECIFIED THE FOLLOWING PERMISSIBLE NOISE LEVEL EXPOSURES:

ACCORDING TO OSHA, ANY EXPOSURE IN THE ABOVE PERMISSIBLE LIMITS COULD

RESULT IN SOME HEARING LOSS. EAR PLUGS OR PROTECTORS IN THE EAR CANAL

OR OVER THE EARS MUST BE WORN WHEN OPERATING THIS AMPLIFICATION

SYSTEM IN ORDER TO PREVENT A PERMANENT HEARING LOSS. IF EXPOSURE IN

EXCESS OF THE LIMITS AS PUT FORTH ABOVE, TO INSURE AGAINST POTENTIALLY

HARMFUL EXPOSURE TO HIGH SOUND PRESSURE LEVELS. IT IS RECOMMENDED

THAT ALL PERSONS EXPOSED TO EQUIPMENT CAPABLE OF INDUCING HIGH SOUND

PRESSURE LEVELS, SUCH AS THIS AMPLIFICATION SYSTEM, BE PROTECTED BY

HEARING PROTECTORS WHILE THIS UNIT IS IN OPERATION.

DURATION PER DAY IN HOURS

8

6

4

3

2

1

1/2  HR. or LESS

THIS SYMBOL IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT

OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE

ACCOMPANYING THE UNIT.

THIS SYMBOL IS INTENDED TO ALERT THE USER TO THE PRESENCE OF

UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT

MAY BE OF SUFFICIENT MAGNITUDE TO CONSITUTE A RISK OF ELECTRIC SHOCK

TO PERSONS.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE CHASSIS. NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

AVIS:   RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.

Summary of Contents for KBA 30X

Page 1: ...e to adapt to all kinds of music this amplifier really delivers what you have been looking and waiting for Whatever style you choose it s ready Kustom with a 30 year tradition of excellence in design proudly delivers to you this amp and rewards you with a rugged and dependable amp designed and engineered in the USA Again thank you for your purchase Please take a few minutes to learn about all the ...

Page 2: ...ong periods of time 12 If this product is to be mounted in an equipment rack rear support should be provided 13 Metal parts and vinyl covering may be cleaned with a damp rag 14 Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation ports or any other openings 15 This unit should be checked by a qualified service technician if A The power ...

Page 3: ...lockwise the low mids will be rolled off 10db Especially good for cleaning up muddy bass guitar overtones 7 Hi Mid this control is the High Midrange control It is active and set to boost or cut frequencies at 1 5KHz This will effect the mid high frequency signals Turning it fully clockwise the signal is boosted 10 db Turning it counterclockwise the low mids will be rolled off 10db Increasing this ...

Page 4: ...he Active E Q you will be able to dial in your preferences from here If you play with a pick and want less top end attack on the notes roll off a bit of the High control If it s deeper bottom your looking for add more low and low mid The key is to experiment to achieve your own personal sound Funk Slap Sounds this style of music needs a good strong attack sound with lots of top end Usually a hollo...

Reviews: