Port-A-Cool, LLC • 709 Southview Circle • Center, TX 75935
www.kuulaire.com • 1-888-999-6511
3
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
ON/OFF
1. Connect the cord to a power outlet.
2. Press the ON/OFF button to turn the unit on.
Indicator light will illuminate. To turn off, press
the ON/OFF button again.
SPEED
Press the SPEED button to select the desired fan speed.
The selected fan speed indicator LED light will light up.
Fan speed settings are LOW – MED – HIGH.
MODE:
Press the MODE button to select the desired fan mode.
The selected fan mode indicator LED light will light
up. When SLEEP or NATURAL is selected, air speed will
randomly vary.
COOL
To use the unit as an evaporative cooler, press the COOL
button. The pump will start and distribute water to wet
out the cellulose media located in the rear of the unit.
After approximately three minutes, as the pad becomes
saturated, the air from the outlet should be cool. When
water in water reservoir is at low level, the pump will
stop. Unit will siren for a few seconds, the COOL light
will flash. The light will stop flashing when unit is
refilled with water.
LOW WATER ALARM FUNCTION
The PACKA44 and PACKA442205060 are equipped with
a low water sensor alarm. When water in the tank is
below minimum level, you will hear 15 beeps and COOL
LED indicator will flash continuously. At the same time
the power to the pump will be cut off to protect the life
of the pump. In order to disengage the alarm function,
turn off and unplug the unit from the power outlet, and
fill the tank with water above the minimum level. In
order to turn off the alarm function and continue to
use it in FAN mode, turn off the unit and turn the unit
back on. If COOL button is pressed again without filling
the tank with water, low water alarm will go off again.
SWING:
Press the SWING button to direct the air stream. The
vertical louvers will begin to move automatically from
side to side. The indicator LED will come on. To adjust
the vertical direction of air flow, adjust the horizontal
louvers manually.
TIMER
The unit comes with an 0.5 hour to 7.5 hour. To set,
press the TIMER button to the desired operation time.
When the pre-selected time has elapsed, the unit will
automatically shut off.
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
ON/OFF – start or turn off the unit
Timer – timer from 0.5 hour to 7.5 hours
Cool – start water pump
Speed – Low/Medium/High
Swing – automatic swing of louvers
Mode – Sleep/Natural/Normal
