10
You might find that extreme VTA height cause problems with the cueing device height ( See
Paragraph 9).
In some extreme VTA situations the tube arm rest height can be readjusted. Release the tube lock
screw and pull up arm rest. (Fig. 5&13) You will notice that below the arm rest is thin plastic plate.
This can be either removed, thus lowering arm rest height, or another added to raise it. You will find
a small spare thin black PVC plate with the accessories.
Fig. 13. Arm rest plate Fig. 13a. Arm rest one spacer plate
7. Azimuth adjustment
To make azimuth adjustments, release the two screws locking the mechanism on the centre top of the
tonearm tube, with Allen key 2mm. Under the main tube is a tiny rod with a hexagonal screw. Insert
the Allen key 2 mm into the screw (it may feel loose), rotate it slightly and it will alter the azimuth.
(Fig. 2 &14a-d)
See Appendix 2.
Fig. 14a. Azimuth adjustment-unlocking
Rotating Allen key back will return azimuth to its previous position. Changes can be seen by
misalignment of the white lines on the top of the centre of the tube.
