9
Fig. 11. Pivot point
6. VTA adjustment ( height)
Set up VTA on this tonearm by releasing the screw in arm base. The VTA screw will prevent the
tonearm dropping down after the locking screw in the arm base is released.
Fig. 12. Adjusting VTA screw Fig. 12a. VTA screw on arm base
One screw rotation changes VTA for 0.5 mm. The VTA screw range is in the range of 30 mm. If you
need to have tonearm VTA adjustment higher, then add the black VTA ring between the arm base
and VTA screw. This will give you an extra 5 mm or 20 mm height. You will find them with the
accessories. See Fig. 12b&12c. Thinner VTA ring you do not fix on pillar with screw!
If you find out that tonearm is positioned too low below the platter you can purchase plastic height
ring to be fitted below arm base. That will raise the arm for about 20 mm. See Fig.1.
Fig. 12b. Black metal ring- optional Fig. 12b. VTA rings