![background image](http://html.mh-extra.com/html/kuzma/4point/4point_instruction-manual_2012685007.webp)
7
3. Setting up the tonearm
Connecting tonearm:
Check the horizontal movement of the tube to ensure that the headshell will reach the inner
grooves (approximately to the edge of record label), but will not travel to the centre of the
record. Also check the arm wire loop and connect the tonearm cable into the phono sockets
of the preamp. (Fig.1)
Due to the high tonearm mass, turntable levelling and suspension should be checked and
adjusted according to the turntable manual.
Fig.4. Assembling the tube onto the horizontal bearing tower.
Cartridge mounting:
Mount the cartridge with the appropriate set of 2.5 mm screws. When fixing cartridge pins be
sure that you do not damage wires under insulation tubes! If you wish you can fix fingerlift at
the side of the headshell- no key required.( Fig. 7A)
Headshell removal and fixing:
This tonearm has a detachable headshell and fixing and positioning it has no negative effect
on tonearm performance. The whole headshell is fixed with one Allen key 2 mm.
Insert it in the top hole and release screw with Allen key for at least one turn (ACW).
(Fig.5&6)
Disconnect cartridge pins, remove Allen key and pull out the headshell. (Fig.7)
Fix the cartridge and return headshell back in to the tube. If it can not be inserted easily,
rotate the screw a little more in ACW direction. Then fix it back in CW direction with gentle
force, around one turn.
vertical bearing point
vertical bearing cup