FEATURES
1) AC Mains Switch
The EPAK 2500R has a combination AC Mains
switch/circuit breaker on the front panel. If the
switch shuts off during normal use, push it
back to the ON position once. If it will not stay
on you should take the unit to qualified service
personnel to have it serviced.
2) Unproper Use LED
If the EPAK 2500R is connected improperly then
this LED will light and the unit will shut down.
3) Limit / Thermal LED
This is a dual colour LED, when green it
indicates that the audio limiter has been
activated. When red it indicates that the
thermal limit of the EPAK 2500R has been
exceeded and the unit has shut down because
of this.
4) Power / Service LED
This is a dual colour LED, when green it
indicates that the AC power is on. When red it
indicates that there is a fault condition sensed
within the EPAK 2500R and that the unit
needs servicing.
5) Signal Present
This green LED indicates when audio signal is
present at the EPAK 2500R’s input.
6) Sub Set Up
This switch is set according to which
combination of subwoofers is being used with
the system. Refer to ‘Using the System’ for
further information, the various combinations
are listed in the table within this section.
7) Hi Freq Level
This controls the output level of the high
frequency amplifier to enable you to adjust the
high frequency component of the ES system to
the desired level.
8) ES 1.0 System
This switch sets the controller for use when
either a single ES 1.0 is being used or a double
system using 2 ES 1.0’s are being used. In this
mode another EPAK 2500R would be required
to power the second ES 1.0 and both switches
should be set to ‘Double’.
9) Master Level
This is the master level control for the system
and will affect both the ES 1.0 and the
subwoofer outputs.
10) Ext Sub Level
This is the level control for the External Sub
output; it is ‘post’ the Master Level control.
11) Sub Level
This is the level control for the Internal Sub
output; it is ‘post’ the Master Level control.
3
1
2 3
5 6
7
8
10
9
11
4
3.1 FRONT PANEL
